You are not logged in. Would you like to login or register?



05-7-2015 21:20:05  #1


Carriage Return Lever--Royal KMG

Hi guys,

I just purchased a KMG typewriter in really nice shape, except for one little problem. At least I hope it's little... The carriage return lever sits too low on the machine and rubs against the top plate when I try to push the carriage back. If it was only a bit of friction I wouldn't mind, but it's so bad the lever actually gets stuck against the plate. I'm wondering if anyone has encountered this before on older machines and how I might be able to fix it. It doesn't seem like the lever itself is bent in any way, just kind of angled downward.

Any thoughts or suggestions would be much appreciated! Let me know if anyone needs pictures for a more accurate depiction. Thanks!

 

06-7-2015 07:01:23  #2


Re: Carriage Return Lever--Royal KMG

Would you mind posting a photo? I have a kmg too, but mine is actually missin the lever.. lol. 


Back from a long break.

Starting fresh with my favorite typer. A Royal Futura!
 

06-7-2015 09:26:51  #3


Re: Carriage Return Lever--Royal KMG

I wouldn't mind at all, actually, except I can't seem to figure out how to get one of the photos I took to show up in the forum, haha. Nothing happens when I try to copy and paste or when I try using "image" button.

     Thread Starter
 

06-7-2015 09:48:49  #4


Re: Carriage Return Lever--Royal KMG

Rufio, I'll post a link to Uwe's 'how to post a photo' thread.

http://typewriter.boardhost.com/viewtopic.php?pid=24#p24

I load all my photos at imgur and then copy the "BB Code" link to paste here at the forum.  Other photo hosts work in a similar way.  It's a little clunky, but I guess it keeps the board free (I think adding board photo uploads requires a paid subscription for the message site, which can be expensive).

Alternatively, you can post the photo somewhere else and then just add a link to it here.

Last edited by Spazmelda (06-7-2015 09:49:20)

 

06-7-2015 19:44:27  #5


Re: Carriage Return Lever--Royal KMG

The carriage return lever is supposed to be parallel to the table and therefore the top of the top plate. I think your lever is just a little bit bent, but a picture would be very helpful in figuring out what's wrong.


A high schooler with a lot of typewriters. That's pretty much about it.
 

07-7-2015 10:10:49  #6


Re: Carriage Return Lever--Royal KMG

I've seen a number of ribbon covers scratched up, not becaus there was anything wrong with the line space lever, but because the ribbon cover itself wasn't seated properly. It's something else to verify.


The pronoun has always been capitalized in the English language for more than 700 years.
 

12-7-2015 21:17:30  #7


Re: Carriage Return Lever--Royal KMG

Hi everybody,

Thanks for all the tips, and thank you for the directions on posting pictures. Sorry I was MIA--just tinkering with the machine! The more I looked at the lever the more I figured it was just bent, probably from bad storage over time. So, with a little elbow grease and the right amount of counter pressure on the carriage, I bent it upwards and now it clears the top plate. Thanks again!

     Thread Starter
 

Board footera

 

Powered by Boardhost. Create a Free Forum