You are not logged in. Would you like to login or register?



28-3-2020 15:28:47  #1


Broken SF escapement

=14pxI recently purchased (luckily very cheap) an Olympia SF that I could tell immediately was going to present a major challenge. The carriage would basically not move if the escapement was engaged. Given the design of this machine, I really needed to remove the carriage in order to see what was going on with the escapement. What I found was very unusual and disappointing. The escarpment wheel would in fact not turn at all. I tried lubrication to no avail and just couldn't figure out why it wasn't budging. I then decided to unscrew it to see if there was just a bunch of gunk underneath. As I turned the screw, I noticed that it would alternate between turning easily and becoming very difficult to turn every half turn. When I got it out I realized why; the screw itself was badly bent! i assume this means this carriage must have taken quite a blow at some point during shipping. I was wondering if anyone is able to spare that escapement screw from a parts only machine? Otherwise I'm afraid mine will become nothing more than a paper weight.
https://www.flickr.com/photos/187639176@N07/49708889218/in/dateposted-public/


____________________________________________
1937 Royal Model O Portable, 1949 Underwood Champion, 1954 Olympia SM-3, 1955 Royal Quiet De Luxe, 1957 Hermes Rocket, 1957 Imperial De Luxe 5, 1959 Smith-Corona Sterling, 1963 Olivetti Studio 44, 1963 Olympia SM-7, 1968 Olympia SG-3, 196X Smith-Corona Electra 120
 

29-3-2020 03:51:56  #2


Re: Broken SF escapement

Dear Mfurst, Where are you located ?  I am in England but may be able to help you with that screw.

 

Board footera

 

Powered by Boardhost. Create a Free Forum