1 of 1- Gaust
- Platen Punisher
Offline - Registered: 26-10-2017
- Posts: 56
Webster XL-500 question
Does anyone know the size of the little pan head slotted drive screws on the back of the typewriter are? I’m missing one and need to order one.
- thetypewriterman
- Key Master
Offline
- From: Leiston, England
- Registered: 29-5-2013
- Posts: 925
Re: Webster XL-500 question
Your typewriter was made by Brother in Japan, so all the screw threads are metric. I would guess that the missing screw would be a M3 thread.
- Gaust
- Platen Punisher
Offline
- Registered: 26-10-2017
- Posts: 56
Re: Webster XL-500 question
Thanks. I suspected that because the M4 screw I found locally would not fit. But I wasn't sure if I should order an M3 or M2.
- •
Thread Starter- Lucas Dul
- Speed Champion
Offline
- From: Chicago
- Registered: 01-1-2018
- Posts: 250
Re: Webster XL-500 question
Order both, better safe than sorry!
Typewriter Service Tech (and avid nerd)
- Gaust
- Platen Punisher
Offline
- Registered: 26-10-2017
- Posts: 56
Re: Webster XL-500 question
I did.
- •
Thread Starter- Fleetwing
- Typewriter Talk Vet
Offline
- From: Hartford, CT USA
- Registered: 30-6-2015
- Posts: 1,011
Re: Webster XL-500 question
What is a good online source for these? I find the local hardware stores only have Philips head, if they have machine screws at all.
- Gaust
- Platen Punisher
Offline
- Registered: 26-10-2017
- Posts: 56
Re: Webster XL-500 question
I ordered from Bolt Depot.com. Each screw is like $.05, but I ordered a packet of 100 for each for less than $3.00.
Of course, shipping is over $4.00.
- •
Thread Starter- Gaust
- Platen Punisher
Offline
- Registered: 26-10-2017
- Posts: 56
Re: Webster XL-500 question
The correct size screws for the back of the Webster XL-500 is M2.5 x 4.5 mm. The M3 was too big, the M2 was too small. Bolt Depot.com has them in pan head.
- •
Thread Starter