You are not logged in. Would you like to login or register?



15-3-2020 19:17:22  #1


WTB: Spring for Remington Noiseless 10

Haven't figured out if I can attach a pic, I have one spring but I need two. It is a small, plain loop-ended spring in the arms for the bale roller rod, one on each side. It fits into a sort of sliding slot and serves to pull the roller rod onto the paper. It is a fairly standard-looking spring, I would be happy with anything that would fit. Its roughly 3/8" long, the coiled part, the loops on the ends adding another 1/8- 3/16" on each end, and about 1/8" in diameter (maybe just a hair more). I don't have a measuring tool to give very close dimensions, I will probably have to work on that if I expect results, but anything close would probably be made to work. I do have good pics of it though, laid next to a tape measure if I could post a pic

 

Board footera

 

Powered by Boardhost. Create a Free Forum