- robmck
- Speed Champion
Offline - From: Seattle, WA
- Registered: 31-1-2022
- Posts: 373
Re: SG Owners Club
Thanks for creating and uploading the models for the paper holder. Looks good. I'd intended on designing one, but then my printer grew progressively less functional and so all 3D design and printing has ground to a halt.
This gives me yet another reason to pull the trigger on the new printer I've been eyeballing...
- del20nd
- New Member
Offline
- Registered: 05-4-2024
- Posts: 10
Re: SG Owners Club
robmck wrote:
Thanks for creating and uploading the models for the paper holder. Looks good. I'd intended on designing one, but then my printer grew progressively less functional and so all 3D design and printing has ground to a halt.
This gives me yet another reason to pull the trigger on the new printer I've been eyeballing...
No problem! It was a good FreeCAD learning project for me.
FWIW, I was able to print it on an Ender 3 V3 KE with normal PLA and at .2mm resolution without any tolerance issues. You do need to print supports for the version with plastic dowels, but they're tiny.
- Pete E.
- Typewriter Talk Elite
Offline
- From: Idaho - USA
- Registered: 23-6-2020
- Posts: 2,396
Re: SG Owners Club
SG-1 for sale for $ 80 on FB Marketplace in Meridian ID...in case some one is hunting. It even has the clear paper support. Those can go alone for $ 40-50 each.
I am not tempted as I have a really great one already.
( Not affiliated with the sale... )
