1 2 Jump to
Standard Typewriters » SG Owners Club » 08-5-2019 06:49:45 |
Messed up one link:
Standard Typewriters » SG Owners Club » 08-5-2019 06:44:57 |
3d printed paper support/gauge to replace the elusive original.
Typewriter Photo Galleries » Show Us Your Restoration Before & After Photos » 06-5-2019 16:50:33 |
1955 SG1, Before & after, including rejuvenated keycaps and 3d printed paper support.
Standard Typewriters » SG Owners Club » 08-12-2018 19:24:42 |
To paint I took the parts to be painted off the machine then removed all chrome strips, logos, and rear identification plate. The parts were scrubbed with stiff brush and various cleaners including Scrubbing Bubbles and Simple Green. I then painted two medium coats of Rust-Oleum Hammered Verde Green over top of the original finish. The results look wrinkled, not hammered.
Standard Typewriters » SG Owners Club » 08-12-2018 16:48:11 |
Neglected to mention 11cpi and manufactured in 1955
Standard Typewriters » SG Owners Club » 08-12-2018 12:49:21 |
Finally getting to posting photos. Mechanically it needed only a few minor type alignment adjustments and a good cleaning. The keycaps were horribly pitted and I smoothed them slightly with fine sandpaper then filled the pits with a clear acrylic finish. Like many SG1s the paint was badly faded from its original green and there was some light damage to the sheet metal, especially along the back, so I decided to repaint as best I could. Here are both before and after:
Standard Typewriters » SG Owners Club » 14-10-2018 08:20:01 |
I am about 2 hours from rejoining the SG owners club. I had an SG3 but just could not warm to its cold, clinical appearance. I passed it along to a young lady who is getting a lot of enjoyment from it. I'v been on the lookout for a locally available SG1 at a reasonable price for the better part of a year, and finally success!
Standard Typewriters » SG Owners Club » 02-2-2018 18:11:06 |
I'm in and out of the SG club in one post. Bought a beautiful SG3 a month or so ago but I just can't warm to it's looks, so on Monday it goes to a new home.
But all is not lost. I'm now on the lookout for an SG1.
Maintenance & Repairs » Hermes 3000 v1 Vertical Adjustment » 23-12-2017 09:39:44 |
An old post, but I have the same question regarding on-foot/vertical alignment on the Hermes 3000. Adjusting the screws mentioned above improved top/bottom balance but caused binding of the carriage.
Maintenance & Repairs » Hermes 3000 - In over my head? » 14-12-2017 15:54:02 |
An entire doner machine was donated to the cause and should be here some time next week.
BTW those bearings are more than a pain to try reinstalling. Six of eight now in place.
1 2 Jump to