You are not logged in. Would you like to login or register?



15-9-2020 07:50:02  #1


Rust v nickel plating

Following from reading Uwe's post on rusty chrome clean-up with aluminium foil.
Does anyone know if it is advisable to use this method on nickel plating? I would think nickel is softer than chrome, and before I venture into cleaning up the nickel plating on my 1930 Remington Portable 3, I would like to make certain it is safe.
thank you in advance,
zoom


There are no answers...  Only choices.
 

15-9-2020 12:11:20  #2


Re: Rust v nickel plating

I haven't had to do much with nickel on typewriters but used to work with nickel plated bicycle parts from pre-WWI and the most abrasive agent I would use would be basically a red gum eraser. maybe a very light buff from some 0000 steel wool, but that's only like a whisper, not rubbing. I've used tabasco sauce on some nickel as well. 
Phil Forrest

 

17-9-2020 22:09:38  #3


Re: Rust v nickel plating

Wow, thank you for your reply and advice Phil. I shall take your advice and try the eraser (the idea had never dawned on me).
Cheers and take care.


There are no answers...  Only choices.
     Thread Starter
 

Board footera

 

Powered by Boardhost. Create a Free Forum