This forum is hosted for free by Boardhost. Create your own free forum!
1 of 1- Typee
- New Member
Offline - Registered: 03-8-2021
- Posts: 14
Erika 9 baseplate
I wonder if anyone knows how to separate a Erika 9 from the baseplate of its wooden suitcase? The feet seem to be nailed rather than screwed together.
- Typee
- New Member
Offline
- Registered: 03-8-2021
- Posts: 14
Re: Erika 9 baseplate
Some additional information that might be useful: The model is an Erika 9 from 1952. I have tried knocking out both the nails themselves from beneath the wooden plate, as well as knocking on the whole rubber-foot. There are rubber washers on both the over- and underside of the plate. Some wiggling is possible, but they don't move a lot when knocked on, and seem very firmly attatched.
- •
Thread Starter- Pete E.
- Typewriter Talk Elite
Offline
- From: Idaho - USA
- Registered: 23-6-2020
- Posts: 2,454
Re: Erika 9 baseplate
Typee,
Here is a photo of the bottom of an Erika 9 from 1954 (photo from the TWDB web site).
And here is a photo of the mounting hardware and bottom plate for my Erika made in the 1970's.
I think your bottom plate has such metal studs that are then press fit into the rubber "donuts" on the bottom of your Erika 9.
I had trouble getting my 1970's Erika off of its bottom plate. I used some silicon oil spray (applying from the inside of the machine) to help lubricate the rubber "donuts" and the metal posts. I used a wide wooden spatula from the kitchen and gently pried each rubber "donut" and the bottom frame of the machine off of its metal stud...with the silicon oil spray helping along.
.
- Typee
- New Member
Offline
- Registered: 03-8-2021
- Posts: 14
Re: Erika 9 baseplate
Thanks! The rubber had become almost petrified, but some silicon oil actually did the trick for me too.
- •
Thread Starter- Pete E.
- Typewriter Talk Elite
Offline
- From: Idaho - USA
- Registered: 23-6-2020
- Posts: 2,454
Re: Erika 9 baseplate
McMaster-Carr on-ilne has a good selection of rubber grommets.
Use their measuring-guide on this page and you should be able to see if they stock what size you need.
.
